Gary,
You are absolutely right! Putting the clone receive window{s} on the Primary
display allows clicking on callsigns, etc. to populate the Entry Fields. I have
been using N1MM for a while (since 2Tone came about) and forgot about that!
Works with XMMT.ocx, so don’t worry about that!
About your question. I didn’t uninstall the Plug-in for writelog. When setting
up any of the Rttyrite windows (including the primary one) you have two
selections for TUType – XMMT.ocx and MMTTY. If you select MMTTY, you get the
Plug-In. If you select XMMT.ocx, you get that. MMTTY will work with either one,
2Tone only works with XMMT.ocx. I found after my last post that TX using
XMMT.ocx and FSK via a COM port can sometimes act a little flaky, so I set up
my Primary RX/TX as MMTTY with the Plug-In and both Clone windows with
XMMT.ocx. So far, so good.
Bob – WB2COY
____________________________
Amateur Radio Station WB2COY
ARRL WAS # 677 23-Jan-09
ARRL DXCC Digital # 2994 6-Dec-11
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|