Just got a new DCU-2. Trying to inferface with Writelog.
I installed the drivers and the virtual com port as per directions with the
DCU-2. This shows up as USB Serial Port (COM8) in Device Mgr. I set up
Writelog's rotator control chosing this port and the DCU-1. The DCU-2 uses
the same protocol.
Should there be a rotator control box showing up on the Writelog screen? I
see nothing different than usual. How is the rotator controlled? Using a
HAM-M.
Thanks
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|