Hi Guys, I am trying to help out a friend and I am stuck.
He is using Writelog and all had been working. Now here is the problem.
He uses the WriteLog CW Receiver mode for CW. It receives CW fine, but
when he
transmit, his outgoing characters do not show up on the Rtttyrite screen.
The
CW does go out and he hears the sidetone.
When He go's into transmit and starts sending CW, the window for the CW
Receiver
that shows the audio signal go's blank, that is, no audio is present while
sending. On my Writelog, the sidetone audio is feed back and you can see
it in
the CW Receiver screen.
So bottom line, He is not getting audio back through the CW receiver which
is
not decoding his outgoing CW and putting in on the screen.
But when He uses Rittyrite for RTTY or PSK, it works fine, with the
outgoing
characters echoing back on the screen.
He is using a Rascal interface. I have been over to his house twice, I
have
checked the sound card connections and the serial ports. I can't find
anything
wrong. It is like on CW, the CW Receiver is set to the wrong side of the
stereo
input??
I checked the Writelog Archives and found a couple of guys had the same
problem,
but no solution was provided.
Thank you,
Joe K0BX
Stop the insanity!
Please do not add me to any distribution lists (Joke, Stories or Junk)
without
my permission.
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/