WriteLog
[Top] [All Lists]

Re: [WriteLog] Can't save config with RTTY clone window

To: <n7us@arrl.net>
Subject: Re: [WriteLog] Can't save config with RTTY clone window
From: Ed Muns <w0yk@msn.com>
Reply-to: w0yk@msn.com
Date: Fri, 27 Jul 2012 16:43:03 -0700
List-post: <writelog@contesting.com">mailto:writelog@contesting.com>
WriteLog only saves two Rttyrite window configurations regardless of how
many you set up, assuming you do a Save Configuration.  You'll note in the
writelog.ini file there are only two Rttyrite sections.  If you setup more
than two Rttyrite windows the second configuration section sometimes ends up
being a mixture of parameters for two or more windows.

The net result is that you have to re-setup all your Rttyrite windows every
time you load WriteLog.  Two years ago, I submitted a request to fix this,
e.g., provide for many more Rttyrite sections in writelog.ini, but nothing
has been done yet.  There may not be enough of us using more than two
Rttyrite windows to justify a fix at this time.

Ed W0YK

 

Jim, N7US, wrote:
> I have WL set up for two radios (actually one K3 with the 
> subreceiver).  I have a Rttyrite window set up for each radio 
> plus a cloned receive window for radio #1 that uses a DXP38 
> for a total of three decoding windows.
> 
> All of that works fine, but when I restart the program the 
> cloned DXP38 window "thinks" it's the Rttyrite window for 
> radio #2 instead of the clone for #1.  I have to change the 
> TU type to MMTTY and the COM port to the second TX port for 
> radio 2 and reopen a cloned window for the DXP38 on radio #1.
> 
> Incidentally, the MMTTY control panel for MMTTY on radio #2 
> is set to "always on top" but I can't see how to change that.
> 
> Am I doing something wrong?

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>