In short, the answer is "Yes". No special instructions needed. Just tell
Tigertronics what radio you
are using, and they will send the 2 necessary cables to connect to the
radio. One goes from the back of
the SignalLink to the radio and the other goes from the back of the
SignalLink to your computer USB
port, Be sure you get the Plug 'n Play board for the SignalLink USB.
With the Plug 'n Play you will
not have to install any jumpers. And, be sure to read the instructions.
I was up and running with my SignalLink within 30 minutes of receiving it.
(I read slow). :)
Dick - W0RAA
I don't Tweet, but I do Toot!
>I am looking for an answer to my question of whether I can use a SignaLink
>USB to run
>Writelog rather than my computers sound card. I would appreciate any
>information you
>can give me regarding this. Thank you,
> 73,
> W3MEL
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|