George,
> We have confirmed that there is a constant +4.5 vdc on pin 14 of the
> LPT connector. It does not go to 0.0 vdc when switching from Radio L
> to Radio R in WriteLog. For some reason, WriteLog is not causing the
> +4.5 vdc on LPT pin 14 to toggle.
What operating system - XP, Vista, Windows 7? 32 or 64 bit?
Do you have the necessary LPT driver (DirectIO) installed and properly
configured?
Have you selected "DVK" in the appropriate LPT line and NA Interface or
Windows Sound Board selected as the DVK type?
These are requirements for LPT operation in WriteLog.
73,
... Joe, W4TV
On 11/12/2011 3:03 PM, Georgek5kg@aol.com wrote:
> Dave and any WL users,
>
> We are back to troubleshooting the SO2R cw keying focus problem. To
> restate the problem, the cw keying focus on the DX Doubler does not
> automatically switch from Radio L to Radio R. The logging program is
> WriteLog, ver
> 10.87e. The DX Doubler will switch cw keying focus manually just fine.
>
> We have confirmed that there is a constant +4.5 vdc on pin 14 of the LPT
> connector. It does not go to 0.0 vdc when switching from Radio L to Radio R
> in WriteLog. For some reason, WriteLog is not causing the +4.5 vdc on LPT
> pin 14 to toggle.
>
> Any ideas will be appreciated.
>
> Tnx, George
>
> George Wagner, K5KG
> Sarasota, FL
> 941-400-1960 cell
>
>
> In a message dated 11/7/2011 5:15:15 A.M. Eastern Standard Time,
> dave.n3rd@verizon.net writes:
>
> Hi George,
>
>
> The most basic response of the DXD is to have the red LEDs transfer from
> Radio 1 to Radio 2 and back when you switch transmit focus. The DXD looks
> for a toggling TTL-level line on its input connector J9, Pin 14, from the
> manual:
>
>
>
>
>
> My first recommendation is to have you put a meter on Pin 14, and then
> change radios on the computer. You should see the level go up and down, and
> actually hear relays click in the DXD. If you can test that, and let me
> know, we can go to the next step of debugging.
>
>
> 73 - Dave
>
>
>
> ____________________________________
>
>
> On 6 Nov 2011 at 21:01, Georgek5kg@aol.com wrote:
>
>
>
>
> Hi Dave,
> I checked the jumpers, and they are set according the instructions in the
> DXB manual.
> The red LEDs only switch when I switch them manually. I could not get them
> to switch automatically regardless of what I did with WriteLog
> I spent the better part of Saturday troubleshooting this problem, but in
> the end just gave up. By 4pm, I had to reconfig the radios and antennas for
> SO1R. I also then went back to WinTest as my logger, as I prefer that over
> WriteLog.
> I'd like to find the solution to the automatic cw focus problem so I can
> go SO2R with the DXB. Are you available to assist me?
> Tnx, Geo...
> George Wagner, K5KG
> 941-400-1960 cell
> In a message dated 11/5/2011 5:50:22 P.M. Eastern Standard Time,
> dave.n3rd@verizon.net writes:
>
>
> George,
>
>
> Are the internal jumpers set properly for WL?
>
>
> If the red LEDs are changing, then the CW and PTT signals should be being
> switched between the two radios.
>
>
> Dave
>
>
>
> ____________________________________
>
>
> On 5 Nov 2011 at 12:40, Georgek5kg@aol.com wrote:
>
>
>
>
> Dave,
> Any suggestions about the problem I have cited below?
> Tnx, George
> George Wagner, K5KG
> 941-400-1960 cell
>
>
>
> ____________________________________
> From: Georgek5kg@aol.com
> To: writelog@CONTESTING.COM
> Sent: 11/5/2011 12:21:49 P.M. Eastern Daylight Time
> Subj: Fwd: [FCG] SOR2 keying focus
> George Wagner, K5KG
> 941-400-1960 cell
>
>
>
> ____________________________________
> From: Georgek5kg@aol.com
> To: support@writelog.com
> CC: fcg@kkn.net
> Sent: 11/5/2011 12:20:42 P.M. Eastern Daylight Time
> Subj: [FCG] SOR2 keying focus
> Hello all...any help with this will be appreciated.
>
> I have set up WriteLog (10.87E) for SO2R using a Top Ten DX Doubler. I
> have all of the functions are working except the automatic switching of CW
> keying from Radio 1 to Radio 2 does not work. I can manually switch the CW
> keying between R1 and R2, ok, but not automatically.
>
> Is there a menu function in WriteLog that I must set?
>
> 73, George
>
> George Wagner, K5KG
> 941-400-1960 cell
> _______________________________________________
> FCG mailing list
> Send mail - FCG@kkn.net
> Change/edit subscription info - http://www.kkn.net/mailman/listinfo/fcg
> FCG Web site - www.floridacontestgroup.org
> Facebook - http://tinyurl.com/4xw5jr7
> DXCluster - telnet to k4fcg.dyndns.org
>
>
> The following section of this message contains a file attachment
> prepared for transmission using the Internet MIME message format.
> If you are using Pegasus Mail, or any other MIME-compliant system,
> you should be able to save it or view it from within your mailer.
> If you cannot, please ask your system administrator for assistance.
>
> ---- File information -----------
> File: hts_1.PNG
> Date: 7 Nov 2011, 5:15
> Size: 54036 bytes.
> Type: Unknown
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|