Anyone can help with K3 commands?
I had the RIT functions running under 10.80d but can't seem to get
them going again in 10.87e.
My .ini file has
[Elecraft_K3_Commands]
Macro_10=ED;
Macro_11=RU;
In Keyboard Shortcuts:
OPEN_SQUARE -->Rig1Command(10)
CLOSE_SQUARE -->Rig1Command(11)
In the lower left corner I get "Error result 1 sending rig command
(11) or (10) depending on which I press.
I also tried setting up the macros in the K3 Utility. I can execute
them fine from the utility and the COM is working otherwise with both
programs (and N1MM too)
Tony
K2NV
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|