The only addition is with a dynamic mike like a heil you need to boost the
drive audio. Little behringer mixer works fine or any small line level audio
amplifier
If you use a PC designed mike then there is no need for the amp. The voice
shaper is also very good to use to route the audio
VK4TI
Trent Sampson
0408 497550
On 09/12/2010, at 10:11 PM, <n1jez@burlingtontelecom.net> wrote:
> Hi Dennis,
>
> I hadn't consider this... It would probably work. I will need to pad the
> laptop soundcard output. It's line level and I need mic level, but that's
> easy.
>
> Tnx,
> Mike
>
> ----- Original Message -----
> From: "Dennis" <egan.dennis88@gmail.com>
> Subject: [WriteLog] DVK with SO2R
>
>
>> MIke
>>
>> Why do you want to use the Rigblaster? The SO2R Box handles audio
>> switching of the mike lead.
>>
>> Plug the mike into the computer.
>> Plug the computer output into the SO2R Box Mike Lead
>> Plug the R1 and R2 Mike outputs into the mike input of the rigs. If you
>> have a K3, you can use the Line inputs.
>> Adjust your levels and you're good to go.
>> On the SO2R Box, make sure that "Mic Relays" box is checked.
>>
>> The SO2R Box has everything shielded and transformer isolated and works FB
>> as a mike audio switcher.
>>
>> Dennis w1UE
>>
>>
>>
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|