Hi Dick,
It should be automatic for the spots in the Packet Window to show up in the
WL Packet Spots Window and on the Band Map if the Ports are correct. In WL
when you click on Window/Packet Window what do you enter in the "Enter IP
name or address for Telnet" for IP Address and Port? I use VE7CC's CC User
interface and usually connect to his VE7CC-1 cluster. For my IP Address I
use 127.0.0.1 and Port 7300. I believe both your cluster and WL have to be
on the same Port for the connection to work properly.
73,
Gary AL9A
----- Original Message -----
From: "Dick Flanagan" <dick@k7vc.com>
To: <writelog@contesting.com>
Sent: September 26, 2010 8:27 PM
Subject: [WriteLog] Displaying Packet Spots
> Now that the contest is over, I would like to pose my question again:
>
> I have two packet windows open: the Packet Window where I log into my
> cluster (dxc.n7tr.com) and the Packet Spots Window where filtered
> spots are displayed.
>
> I am able to log onto my cluster in the Packet Window and I see all
> the spots scrolling past. However, nothing shows up in the Packet
> Spots Window or on the Band Map.
>
> How do I get the Packet Window to communicate with the Packet Spots
> Window?
>
> Thanks again for everyone's help.
>
> Dick
> --
> Dick Flanagan K7VC
> dick@k7vc.com
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|