Hi Joe,
I have a similar command listed in my IC-7600 manual on page 154.
Cmd. 1A Sub cmd. 050085 Data 00 Quick RIT/TX clear OFF
Cmd. 1A Sub cmd. 050085 Data 01 Quick RIT/TX clear ON
The problem is the word "Quick". With Quick RIT/TX clear OFF you must press
and hold the CLEAR button on the radio for 1 sec. to clear the RIT/TX
offset. With Quick RIT/TX clear ON you need only touch the CLEAR button for
the RIT/TX offset to be cleared immediately. These commands only turn the
"Quick" set feature on or off. Neither one of these commands will clear the
RIT/TX offset via a string from a software program.
73,
Gary AL9A
----- Original Message -----
From: "Joe Duerbusch" <jduerbusch@sbcglobal.net>
To: "'Barry Merrill'" <barry@mxg.com>; <writelog@contesting.com>
Sent: August 02, 2010 6:32 PM
Subject: Re: [WriteLog] RIT Clear on the IC-7000 doesn't seem to work *
> BTW I did RTFM. On page 145, middle of first column subcommand 050077
> says
> Send/read quick RIT/TX clear function (0=off, 1=on)
>
> The manual was the first thing I checked before sending out the query. I
> have not tried it yet, but in Ham Radio Deluxe there is a function on one
> of
> the menus that allow you send commands to the radio to test the civ. I
> guess I need to try the command and see if it works.
>
> -----Original Message-----
> From: Barry Merrill [mailto:barry@mxg.com]
> Sent: Tuesday, August 03, 2010 01:02
> To: k0bx@arrl.net
> Subject: RE: [WriteLog] RIT Clear on the IC-7000 doesn't seem to work *
>
> Did you RTFM to see if the command exists?
>
> Prior posts all point to NO for Icom Clear RIT being a command.
>
> 73
>
> Barry, W5GN
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|