Hello,
I purchased a Dual Serial CW and Rig Control Cable from K1NU. I have it setup
on comm 2 in WL. I am using version 10.53 on a XP machine. The cable reads
the radio frequency just fine and changing bands the frequency follows.
My problem is that when I plug the CW keying cable into my ICOM IC-761 it keys
the transmitter ? Apparently the serial port is not configured correctly in WL
? In checking with K1NU he suggested that I make sure the CW & Rig are on the
same port and further suggested that Comm PTT =NO and that the All Mode PTT NOT
be checked. I tried that but have the same problem that the radio keys in XMT.
When in the ports set up I check the CW and the little dot appears but when I
save the configuration and bring WL backup the little dot is gone ????????
Would appreciate some comments from someone who is using one of K1NU's dual CW
& Rig control cables and maybe how your INI file is set up.
I have attached a photo of my port set up. Noticed that the check mark
disappears when I save the configuration ?????????
Gary K7OX
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|