> Writelog does not show the FT2000 frequency.
> When clicking the Frequency Window, the message
> "rig on Comm 5" is shown , so WL seems to find Com5
> When the SET button is clicked a "No rig" message results.
When WriteLog starts, Does Router show "open 4800 8N2" in
the CAT port? If not, WriteLog is not opening the correct
port.
> In the RIGS section of Writelog.ini I have
> Com5: =4800,n,8,2
I do not believe there should be a space between COM5: and
=4800.
Have you turned off the handshaking (Menu 29) in the FT2000?
What handshake options are you using with DXLab/Commander?
Is WriteLog using the same options?
73,
... Joe, W4TV
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com] On Behalf Of Wolf, DK1FW
> Sent: Thursday, December 04, 2008 3:52 PM
> To: writelog@contesting.com; microHAM@yahoogroups.com
> Subject: [WriteLog] Writelog: FT2000 on MicrokeyerII not
> recognized - NEEDHELP
>
>
> I recently added an FT2000 and MicrokeyerII / Router 7.2.2 to
> my station. FT2000 CAT is on COM5 (4800,n,8,2), RTTY on COM6,
> WinKey on Com7 and CW
> PTT on Com8.
> That configuration works flawlessly with DXLab under XP SP3.
>
> As my old version of Writelog supported neither the FT2000 nor the
> FT9000 I upgrade to WL 10.69D.
> When trying to get WL to communicate with the FT2000 I ran
> into trouble. After 4 hours of fruitless attempts I am totally lost.
>
> Router is running and tracks the frequency of the FT2000 on
> Com5. Writelog is started after that.
>
> In the PORTS section of Writelog.ini I have
> CommSlot1=5
> In the RIGS section of Writelog.ini I have
> Com5: =4800,n,8,2
>
> In the Writelog Ports Setup I have
> Com5 - FT2000 - 4800 - Poll hooked - NO PTT
>
> CW and DVK are not selected in this initial attempt to establish
> communication with the rig.
>
> Writelog does not show the FT2000 frequency.
> When clicking the Frequency Window, the message "rig on Comm 5" is
> shown , so WL seems to find Com5
> When the SET button is clicked a "No rig" message results.
>
> DXLab is not running so there should not be any competition for Com5.
>
> Writelog worked perfectly with my FT1000D using the Com1 to Com3
> hardware comports of my computer for CAT, FSK and CW keying.
>
> Any ideas what I might have missed.
> Any ideas what I may done wrong.
>
> Your help will be greatly appreciated.
>
> TIA es 73 de Wolf, DK1FW
>
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|