Hi again Eric.
If you have run this before and it worked with Writelog, I would
certainly like to compare settings with you.
Richard - K5NA
At 16:42 2/11/2008, Eric - VE3GSI wrote:
>Richard,
>
>I noted in another post you mentioned you use PC generated CW. Set-up with
>the WinKey option try again.
>
>I have run CW SO2R with the mH SO2R+ Keyer and don't remember your problem
>when set-up with the WinKey option. I am pressed for time today, but as soon
>as I can I will check your findings here and get back to you - most likely
>direct if that is ok with you.
>
>73 Eric.
>
>
>
> > -----Original Message-----
> > From: Richard L. King
> > Sent: February 10, 2008 11:03 PM
> >
> > I need some help again to make something work on my MK2R+ with
> > Writelog. I had this problem a year ago, but was told that it should
> > work when Writelog implements support for the MK2R.
> >
> > Now I am running Writelog 10.65C that should have support for the
> > MK2R but the problem is still there. Here is what happens.
> >
> > I have a CQ TEST in F1.
> >
> > I have "K5NA" in F4.
> >
> > I am running in SO2R mode and using auto repeat (3 seconds) and auto
> > resume to send the F1 CQ on radio one.
> >
> > The headphones are switching and I am listening on radio two when
> > transmitting on radio one.
> >
> > I use the "shift arrow" key to move the keyboard focus from radio one
> > to radio two. Radio one continues to call CQ with the transmit focus
> > still there.
> >
> > I decide to drop my call in on radio two using the F4 key.
> >
> > This is where things go wrong.
> >
> > When I hit F4, radio one only stops for an instant. The PTT switches
> > to radio two and then immediately back to radio one. Nothing is sent
> > on radio two even though the PTT was made briefly.
> >
> > Radio one has immediately started CQing again. When that CQ completes
> > there is no pause and another CQ starts immediately. Then, finally,
> > after the second CQ the 3 second delay will be injected between CQs
> > again. Then it starts CQing normally with the 3 second delay
> > between CQs again.
> >
> > With the auto CQ and auto resume on, I cannot send on the second
> > radio by moving the keyboard focus there.
> >
> > Is there something that I have missed in the Router or Writelog that
> > makes this work correctly? I have been playing with settings and
> > reading material and I can't get any ideas.
> >
> > I am cross posting this to Microham in case it is a MK2R or
> > Router issue.
> >
> > 73, Richard - K5NA
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|