Hi Seli,
I think it may be a simple fix. The CommSlot command is case sensitive so
it should be as follows:
CommSlot2=6 not Commslot2=6. Good luck.
73,
Gary AL9A
----- Original Message -----
From: "A.Oskarsson" <tf3ao@simnet.is>
To: "WRITELOG" <writelog@contesting.com>
Sent: January 29, 2008 12:27 PM
Subject: [WriteLog] ICOM CIV
> I'm trying to get WL to read the freq. from my IC-756PROII. So far I
> haven't
> succeeded.
> Interface is only for reading the freq. and is connected to USB port no.
> 6,
> and that setup works with MixW, N1MMLogger and Logger 32.
> I have inserted in the INI file the following command: Commslot2=6 and it
> shows up in Setup > Ports window.
> Tried different baud rates, and so on, but no gain, just pain.
> Suggestions?
> 73 Seli TF3AO
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|