Brian,
Do you have the CW column checked in the ports setup for the comm port you
are using to control the 7000? If so that is your problem, that will cause RTS
and DTR to not be asserted, removing power from the CIV interface. This assumes
that you are using a CIV interface that is powered from the comm port.
See the "Rig Interfacing" section of the WriteLog help file.
Gordon - N1MGO
On 23 Jan 2008 at 16:37, Brian Sarkisian, KG8CO wrote:
> I cannot seem to get the computer to control the rig using Writelog.
>
> The rig is an IC-7000 and the computer is a laptop and I am using one
> of the USB ports.
>
> USB Port is Com 1 and have set Writelog to talk with the radio at 19200
> baud and also in the automatic mode. No dice
>
> Here is the kicker ....
>
> I can use the current USB interface cable with the Com 1 setting and
> the baud rate of 19200 and it works fine with Logger 32 and the Syslabs
> Radio Control program.
>
> What am I missing?
>
>
> Thank you
>
> Brian, KG8CO
>
>
>
> ______________________________________________________________________________
> ______
> Be a better friend, newshound, and
> know-it-all with Yahoo! Mobile. Try it now.
> http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|