Per the WriteLog Help manual:
There are 4 "slots" available for WriteLog rig interfacing. By default,
CommSlot1 is COM1:, but you can change that by changing the number on the
right of the equal sign. These settings are not used for RTTY or for packet
CommSlot1=1
CommSlot2=2
In this example, the third and fourth slots are on COM7 and COM8. COM15 is
as high as is supported.
CommSlot3=7
CommSlot4=8
Your CommSlot1=5 setting would go in the [PORTS] section of the writelog.ini
file.
Gary AL9A
----- Original Message -----
From: "George Rickley" <Grickley@comcast.net>
To: <writelog@contesting.com>
Sent: August 27, 2007 11:43 AM
Subject: [WriteLog] (no subject)
> Hi All,
>
>
>
> How and where do I use the CommSlot1=5 command?
>
>
>
> Thanks,
>
> George K1MA
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|