Dave,
I can only offer that the UserPara.ini file belongs to MMTTY. When the
MMTTY plug-in initializes, this file is used to build all the DSP filters
that you see under the Profiles menu.
Jerry, W6IHG
At 11:16 PM 1/6/2007 -0500, David Fisher wrote:
>David Fisher wrote:
>
> > I am using WL 10.61E with the MMTTY plug-in on Windows XP. The RTTY
> > rig hr is the Icom 706MKIIG and the interface is the Rigblaster Plus.
> > I run FSK.
> > This system has worked well in the past, but as I prepare for this
> > weekend's RU, I find that my tx doesn't stop even though I have %E in
> > my messages. The only way I can get the rig from tx to rx is to
> > manually hit the escape key and even then there is quite a lag until
> > tx stops.
> > This problem now also exists with old contest formats that performed
> > perfectly in the past with the existing equipment.
> > Can you help?
> > Dave KA2CYN
> >
>My further attempts to resolve this situation lead to more confusion
>here. Hopefully what I relate below will make sense to someone out there
>re where a solution may lie.
>I tried to use MMTTY as a standalone. It produced the similar problems
>with tx as described above. So I figured that I should try WL without
>the plug-in.
>WL with the RTTY Rcvr gave me no decent copy on rx. On tx, rttyrite
>produced only the 1st 5 spaces any any given msg. Tx than hung up, but
>the manual esc key resulted in immediate tx to rx (no lag).. ALT K tx
>acted the same way-tx 1st 5 spaces in rttyrite window and then hung up
>when ESC key was hit.
>Sometimes when I start WL I get an error msg. This has been going on for
>some time (even when the program worked flawlessly) but I will describe it:
>It pops up intermittently upon WL start and reads "UserPara.INI"
>followed by graphics which are not on my keyboard.
>
>I then ran my virus program. All reported fine.
>
>My next thought was that my copy of WL was corrupted. I made 2 attempts
>to download a replacement copy. In both cases
>I got a message as follows: "There is a problem with the Windows
>Installer Package. A program required for this installation to complete
>could not be run. Contact vendor."
>
>I've been working rtty tests for a long time and I hope that someone
>reading this can help me get back in the game.
>73, Dave KA2CYN
>_______________________________________________
>WriteLog mailing list
>WriteLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog
>WriteLog on the web: http://www.writelog.com/
------------------------------------------
Dr. Jerry R. Pixton, PIXOS Designs LLC
http://www.pixos.com/designs/RadioTuner/
jpixton@shentel.net
------------------------------------------
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|