Since it was mentioned that this new feature, the %Z, is being revised
in the next release I thought I would put in my request again and be
perhaps a little clearer this time.
For SO2R on CW, appending "KHZ" onto the end is a waste of precious
time. The typical CW sent is: "PSE QSY 140125" or just: QSY 14025?,
nobody ever sends "KHZ." Can we do away with the "KHZ" or add an option
to turn it off?
More important, many stations - this one included - can run and do run
on either radio. If I am running on radio #1 I need the "QSY 14025?"
message to pick up the frequency of radio #2, but, also, vice versa.
Can we have a %Z (with an appendage) that sends the frequency of the
radio that does not have transmit focus at the time of sending? I
realize this gets hard if there are more than two radios involved. Just
having it send radio #2's freq when radio #1 is TX and vice-versa will
make this really useful however for nearly all SO2R ops.
Hal
N4GG
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|