After some help from Joe, I was able to configure the router to provide this
capability.
I had DXBase2006 on my secondary computer watching for any unconfirmed
band/mode cluster
spots.
I had Writelog using the MMTTY add-in module running on the main monitor.
Both programs were being fed cluster spots from ARUser.
The active preset was my Writelog preset.
Both programs could control the rig by choosing the correct preset.
So when a cluster spot sounded an alarm on DXBase for a band/mode I needed, I
simply
clicked on the DXBase preset, clicked on the cluster spot which switched my rig
from 20
meter FSK to 30 meter cw, hit my keypad cw message buffer, worked, logged him
and switched
back to the Writelog Preset and continued working BARTG.
My only inconvenience is that my rotor control which is on a legacy comport
card had to be
disabled in DXBase so that it could be controlled by Writelog.
Slicker than snots on a doorknob....
-----------------------------------------------------
T-Shirts - taglines for the Computer Illiterate.
-----------------------------------------------------
Bill H. in Chicagoland
webcams at http://24.14.49.4:8080
weather at http://mywebpages.comcast.net/w9ol/WX/HH.htm
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|