Hello,
I recently installed Writelog 10.55d on my Windows 2000 laptop for use with
my FT-1000D.
I have a Microham USB-YS Interface box that connects to the CAT DIN jack on
the FT-1000D.
The other end of this interface connects USB to my Windows 2K Dell Latitude
computer.
The Hardware Manager / Device Manager in my Windows 2K laptop show that the
MIcroham USB-YS interface installed as a device in the USB device list.
The only comm. Port on my laptop is Comm 1, and although an active comm.
Port, it is currently not being used.
When I launch Writelog and go to the Port configuration area, I am able to
Select FT-1000D adjacent to the COMM 1 line, however, it is a comm virtual
comm. Port mapped to the USB-YS interface that is needed, so that the CAT
jack will send frequency data over to Write Log.
So, right now, I have a good serial port on Comm 1, and I have a properly
installed USB-YS interface device, however, I don't have any mapping from
either COMM 1,2,3,or 4 for my USB interface.
It used to work, however, I am not sure why not now, unless there has to be
a special edit made to the Writelog.INI file??
Any help would be appreciated.
Thanks,
Jim
K4PV
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|