Having a problem reading an FT-897 on com1. When the port setting is set to
auto, there is no communication. With the rig and WL set to 9600 or 4800 baud,
there is communication but it is flaky. If I force the rig to TX, WL reads the
freq okay, but on Rx, it often reads the wrong freq. Also, CW keying is okay
out of com1 using alk-K but not the F keys.
Ideas?
Hal
HP1/N4GG
(Why does this always happen in the field?)
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|