Error 487 is 'invalid address' - you may have the option of defining the
actual address for your printer port. Although there are recognised defaults
these are not cast in stone.
Simon Brown
---
www.sysgem.com www.hb9drv.ch www.laax.ch
----- Original Message -----
From: "Stan Staten" <stan.staten@verizon.net>
> Saw recent WL list post on Direct I/O and sure enough it is updated
> since I last tried it. However, I still am not able to get the LPT1
> port "un-greyed" out. Also getting the following error when I run IRQ
> Monitor: "Error 487 occurred when trying to open Direct I/O". Error
> reports have gone unresponded to by whoever sees them. Any suggestions
> as to where to turn would be sincerely appreciated.
>
> 73 Stan, N3HS
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|