Jon,
Go to Tools/Keyboard Shortcuts
Go down to F11 and change it to entryclear
This will now act as entry clear instead of CQ
Ric KV1W
-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com]On Behalf Of Jon Suehiro
Sent: Thursday, April 28, 2005 3:58 AM
To: 'WriteLog Reflector'
Subject: [WriteLog] CtCompatibleAccel=YES
After using WL by UPGrading for years, I just fresh re-installed while
replacing the aged hard-drive.
Installed WL1051Mfull provided by Ron at the time of renewal, then UPGraded
to WL1054CUPG (plus, MMTTYPlugin_V13). Every thing seems back to the way
used to be. Except one thing.
When CtCompatibleAccel=YES was added into [Configuration], my original
setting not only made F1 key for CQ-ing but also F11 for wipe QSO.
Currently I am getting CQ-ing on both F1 and F11 (Setup -> CW/RTTY/SSB
messages... indicates as F1&F11 to agree with the condition).
How can I make F11 as wipe QSO instead of Alt + Q ?
I looked at the old WriteLog.ini to see if I am missing, but don't see any
particular line ... Nothing mentioned in Scot's site either.
Thanks for your help.
73 de NN5T, Jon
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|