I put up an RC2800 two years ago and it worked fine. I connected it
with a straight-through 9pin D connector cable to a real serial port,
disabled the Palm Desktop Hotsynch Manager, used Setup/Ports to
specify COM1:, RC2800 and WL controlled it just fine. Note that
programs like Hotsynch and various modem-oriented products can tie up
a serial port even when they are not "running." This could be your
problem.
Note that the new Tools/Keyboard Shortcuts lets you specify a single
keystroke to turn the rotor to the azimuth of the call in the active
QSO window. I use F12 but may swithc to [.
Finally, note that there is also a nifty piece of freeware called
RFW.exe that displays the current setting of one or two rotors both
numerically and with a pointer on a circle and lets you click on the
circle to command the controller. It depends on Writelog being in
operation, though. It's not a standalone program.
/Rick N6XI
On Fri, 5 Nov 2004 06:33:37 -0000, David J. Strout - W2YC
<djsatty@comcast.net> wrote:
> Can someone unlock the secret for me? New M2 rotor works fine in Hyper
> Terminal, but cannot interface with WL. Tnx. Dave, W2YC
> Mail
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|