I figured it out !
In the setup great circle bearing area we must ensure that the Beam
heading
Great Crcle Bearing CONTROL Properties area
Shows the display items wanted as enabled
anything with a - (minus) is not displayed
just changing that minus to a 1 did it !
hope this post helps some one else instead of just wasting band width :)
steve
KG5VK
-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com] On Behalf Of KG5VK Steve
Sent: Saturday, October 30, 2004 7:18 PM
To: writelog@contesting.com
Subject: [WriteLog] I installed the cty files and converted them but
stiill do not see Beam headings
How do I get to see Beam Headings ?
I see Sunrise/set but no beam headings
What am I doing wrong ?
Tnx in advance
73
steve
KG5VK
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|