George,
Although it isn't specifically a WriteLog question, I put it on the reflector
because a more knowledgeable person about WriteLog might have known a switch,
parameter, function, or other method that would allow WriteLog to automatically
take care of the issue for me without the requirement for me to manually edit
the Cabrillo file. If such existed, that would eliminate my requirement to edit
the file, even though it will probably be done as a "replace all" type of
operation.
73, Jerry K0TV
----- Original Message -----
From: Georgek5kg@aol.com
To: k0tv@arrl.net
Cc: writelog@CONTESTING.COM
Sent: Monday, November 01, 2004 10:40 AM
Subject: Re: [WriteLog] Multi-two cabrillo file
In a message dated 11/1/2004 5:52:01 AM Mountain Standard Time,
k0tv@adelphia.net writes:
Hello all,
I ran M/2 last weekend using WL 10.50 and TCPIP networking.
I ran four stations, but didn't violate the M/2 rules. When changing bands,
we went to a new station most of the time. The Cabrillo file lists transmitter
0, 1, 2, and 3. This is the first time I had four stations set up. In previous
contests, we used only two stations.
My question, will the folks at CQ correctly figure out that this is a M/2
entry and not M/M? Do I have to go in and edit the Cabrillo file to show the
band changes?
73, Jerry K0TV
Jerry,
I think that your question is more appropriate for the CQ-Contest reflector
than the WriteLog reflector. I don't view this as a WL issue. Perhaps you
should send your question directly to the CQWW contest committee.
73, George, k5kg/7
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|