Hi,
I am trying to use write log or rttyrite to decode and send CW. I am using a
Tigertronic Signal Link Model SL-1 as my interface between my Icom 745 and my
computer. The sound card works just fine for PKS31 and I think I have the
volume levels set correctly. The test of the sound card was just fine. I also
have available, but have not used as of yet, a W1WEF interface for my old CT
logging program. I also have printed K9JY's setup information and gone through
it as well as the setup material from WriteLog. I am using Writelog v. 10,41B
My questions:
1. Is it possible to use the SignaLink as my sole interface for PSK31,CW, and
RTTY or do I have to use my W1WEF interface as well?
2. Which CW section do I use -- the one internal to WriteLog or the RTTYRite
program?
3. How do I set up the Ports for CW if I do not use a COM or LPT port for CW?
4. When I try to set the sound card setup sound card window to check enable
recording loop and turn off echo microphone for CW I get an error message: "can
not enable loop is sound board in use?" I am not aware of any other program
using the sound card at this time. -- also when I tried to us the CW program
the transmit on my rig kept shifting on and off until I unchecked the echo
setting on the sound card set up.
5. If I do need to use the W1WEF interface -- do I set this up on LPT CW
setting? How will this effect the computer, radio & SignaLInk interface in all
modes, exp. CW, RTTU etc.
Sorry this is so long. I really want to get writelog gone before contest season
and be able to use all its features. Unfortunately my rig is not computer
compatable but such is life.
Tim
KA9ORN
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|