McKay wrote:
Hi guys
I use WriteLog configured for Com port 1. The OS is Windows 98. Recently I
downloaded MMTTY and in order to get another com port I installed a serial
card with dual ports. Now, my ports show "5,6, and 7". When I called up
WriteLog for the RAC contest there was no rig control. It was still set on
Com 1 but apparently Com 1 has changed to something else. Writelog only
allows com 1 through 4 and my computer now only shows com 5,6 and 7. Any
suggestions?
Archie, K4GA
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
Hi Archie,
Try adding the line CommSlot1=5 to your ini file under the [Ports] section.
I open my ini. file in 98se by clicking the Start |Run|type in writrlog.ini
and enter. This should open your writelog.ini file in notepad where you can
add the command. Be sure to save after you make your addition.
Take a look at www.k9jy.com for more information. Good luck.
Bill N8KM
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|