I had that problem several years ago with a Kenwood 850. If I remember
correctly, it was due to the fact that I was using the "B" VFO. The spot
clicks only work if you are using the "A" VFO.
Give it a try.
Jim - KK7A
*********** REPLY SEPARATOR ***********
On 11/15/2003 at 8:12 PM Bob Marzari wrote:
HI,
I am trying to figure out what is not configured properly in my
daughter-in-laws WriteLog program.
When stations are spotted on the bandmap and you double click the band map
switches momentairlly to the correct frequency but the radio never does and
does not follow. Yet, Her Kenwood 690 when manually tuned will show on the
bandmap the proper VFO tracking as you tune across the band.
However, When using DX4Win and the same comm ports radio will go to a spot
clicked on in the packet window.
What are we doing wrong?
I run WriteLog and have not seen this happen on my computer.
TIA
Bob and Kathy, W3PT and KB3AGR
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|