More things to check:
1) Have you defined operators using the Entry/Change Operator menu? If so, WL
will be looking for operator subdirectories in the
..\WaveFiles area.
2) Click the main WriteLog window's Setup/Ports menu to open the Port Setup
dialog box.
Click the Wave File Locate button in the lower right of the dialog box.
Use the pop-up window to navigate to the C:\Program Files\WriteLog\WaveFiles
directory.
Click on a .WAV file in this directory.
Note: you do NOT browse for this file from the Setup/CW/SSB/RTTY Messages
pop-up window!
3) Before you do the above, make sure that all recorded wav files used for
messages are in PCM 11.025 kHz 16-bit mono format.
-- Eric K3NA
-----Original Message-----
From: Al Bailey [mailto:k8six@comcast.net]
Sent: 2003 November 12 Wednesday 00:02
To: eric@k3na.org
Subject: RE: [WriteLog] Audio Help.
Nope that is O.K. as I just looked and it is pointing to the correct
directory. Back to the
drawing boards . :( :(
At 11:51 PM 11/11/2003, you wrote:
>Have you set the INI file entry to point to the directory with the .WAV
>files in it?
>
>-----Original Message-----
>From: writelog-bounces@contesting.com
>[mailto:writelog-bounces@contesting.com]On Behalf Of Al Bailey
>Sent: 2003 November 11 Tuesday 23:47
>To: writelog@contesting.com
>Subject: [WriteLog] Audio Help.
>
>
>I am still trying to get WL to use the WAV files I created but I can't even
>get it
>to see any files with the wav extension. Here is what I have done so far.
>
>1. Created a good size group of wav files and placed them in the
>Writelog/Wave Files/
>directory.
>2. Made sure the rig is on SSB and in the SSB portion of the band.
>3. Writelog Soundboard Setup I have checkmarks for Enable recording loop
>and also
>Echo Microphone.
>4. In PORT SETUP I have Windows Sound Board selected.
>5. I then go to Rtty/CW/SSB Memory Setup and removed MSG2 from F2 and in
>its place put
>%C so it should grab the call.
>6. I also selected SSB
>
>Note: at this point I tried to browse for a WAV file but it will only look
>for a .WL or .CNT file .
>
>7. I forgot to mention too in the Port Setup dialog box I went to Wave File
>Locate and
>let it know which directory my wave files are in.
>
>With all that setup I enter a call and hit F2 and it does nothing.
>
>What step or steps have I forgotten or what am I doing wrong ??
>
>_______________________________________________
>WriteLog mailing list
>WriteLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog
>WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|