If the computer is permanently connected to the radio, this is going to
happen as the operating system initializes its output ports. My computer
connects through a DX Doubler switching network so I fix the problem by
putting the DXD transmit mode switch in Manual during O/S boot. If you
have no such switch, you could put one in the tx key line or just turn
off VOX and BK-IN on the FT-1000MP. (The other FT-1000's may have
differently named controls but you get the idea.)
73,
/Rick N6XI
W7OM@aol.com wrote:
When the computer comes on during, the FT-1000 key line locks up. By going
to WriteLog Setup/Ports and checking Okay, the lockup is cleared. I am using a
keying interface for both the cw and PTT lines.
How do I clear the lockup upon initialization of the computer? WriteLog does
not seem to be in the Start file.
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|