Kelly,
I did not have any problem when using LPT1 for CW and COM for rig control
but,,
Your problem sounds the same as I had. I always used LPT1 for keying
and COM1 for rig control.. I had a cable made for both keying and rig
control via COM1...When writelog was started, the rig would key and stay
keyed until I exited writelog...Loading the patch from the link that
I gave you fixed the problem...If it does not, you may have a problem
with your control cable...Also when in writelog, setup, ports make sure
All Mode PTT on CW is NOT checked.
Lee, N5PO
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|