More troubleshooting....
I hooked the rotor port to another port and monitored the data...
Looks like Writelog is not sending a carriage return when the heading is
sent.
All that is send is the heading. Albeit 1, 2, or 3 digits long. The rotor
will respond to 1, 2, or 3 digit directions. But it MUST have a carriage
return to act on the heading sent.
Any ideas?
Thanks and 73
Jim W7RY
----- Original Message -----
From: "Jim W7RY" <w7ry@centurytel.net>
To: <writelog@contesting.com>
Sent: Tuesday, October 28, 2003 9:35 PM
Subject: [WriteLog] Fw: M2 Orion OR-2800 Rotor
> Well just received my new Msquared OR-2800 rotor. Have it set up in the
> shack.
>
> I can't seem to get it to work with Writelog. Works fine with Hyperterm. I
> can tell it where to go all day...
>
> I can see the data go out from the comport when I use Writelog, but the
> rotor does not turn.
>
> Any ideas? Just searched the archives and no luck.
>
> Thanks and 73
> Jim
>
> W7RY
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|