I may need some help here since it's been "ages" since I used a PK232.
I had a similar problem with my new shack computer and talking with my
DXP-38. Try this. Go to the writelog.ini file and look under [Ports]. There
should be some entries like this:
COM1:=9600,n,8,1,
COM2:=9600,n,8,1,
or
COM1:=9600,n,8,1,x
COM2:=9600,n,8,1,x
If there is an "x" at the end of the port you are using, delete it but leave the
comma. The default speed for talking to a PK-232 is 9600 I think
If there is no entry for the port you are using, create one just like the
first example shown above.
Be sure to save the changes to the writelog.ini file.
73, Don AA5AU
----- Original Message -----
From: "David Fisher" <d.c.fisher@att.net>
To: <writelog@contesting.com>
Sent: Saturday, September 06, 2003 2:40 PM
Subject: [WriteLog] Can't Intialize PK-232MBX
> I cannot get WriteLog to initialize my PK-232 when setting it up for
> RTTY.(Using Win XP) I set it up in the ini file at 1200,n,8,1 on com
> 1.
> I also tried 2400 baud as that works with WF1B's software on my WIN
> 95
> machine.
> HyperTerminal gives me an "ok" at both baud speeds. Auto detect shows
> "115200 8-N-1"
> My mode & port selections are as per your write-up.
> the ini.file is saved as a text file after I edit it. I did notice
> that
> the "speed" section remains as edited after I save it. (i.e.. I exit
> the
> file and then re-open it and the changes are there). But if I go to
> the
> contest menu and than return to the ini.file the speed "section" is
> blank--it looks like it was never edited.
> Can you give me any suggestions re how to resolve my problem?
> 73, Dave KA2CYN
> ka2cyn@arrl.net
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|