OK Gang,
Have new rig, Kenwood TS-2000. Have kenwood software to run rig that
works
fine and have Writelog talking to the rig via com 1. Have LPT port keying
ok for CW. How do I use the serial port keying on other modes via the
MFJ-1275 when I only have ONE SERIAL PORT? Can it be done? How? Tried to
use a USB to Serial DB-9 converter but it didn't work at all as rig control
so I figured it won't work for anything else either (and it didn't). IDEAS?
OH, and I still haven't' gotten to the rotor control down the road that I
will also need another serial port for. Does anyone make a single serial
port input X four serial out in DB-9 ???
Mike Baker K7DD
k7ddmjb@qwest.net
|