Hi Bill,
I don't know if it is possible to use one COM-port only for rig control
and cw for the FT-1000MP. This question seems to be not very important
because you have to think about PTT also. And I didn't succeed at all
to key the PTT of my FT-1000MP via the rig control with WriteLog. So
you will need a second COM-port for PTT. And you can use this COM-port
for cw and PTT together.
Or did you manage to drive the FT-1000MP-PTT via the rig-control
commands? That solution would be of interest for me.
73 + 55
Wolf, DL6JZ
FireBrick wrote:
> I'm trying to help a logging software author.
> Is it possible to run FT1000MP rig control and cw off the
> same com port?
> http://www.aa5au.com/rttyinterface.html
> This is the identical interface that I built for myself
> way back when
> and I presently have it on com 1
>
> My Yaesu FT1000MP is presently connected to com 2 for rig
> control.
> If I was to open the com port cable connector and spliced
> a pair of wires to
> the DTR & Ground, used a transistor/resister to the cw
> jack, will that work?
>
> I don't know if the MP uses the DTR line.
>
>
> -----------------------------------------------------
> Change is inevitable, except from a vending machine.
> -----------------------------------------------------
>
> W9OL, Bill H. in Chicagoland
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
|