Hi Larry:
Thanks for your help and support.
Everything has been done accordingly with the instructions.
In the position manual it is all ok.
I will check the pin 14.
I will test another parallel cable also.
I?m using the last version of WL the 10.40
73
Oms PY5EG
-----Mensagem original-----
De: Larry Schimelpfenig [mailto:k7sv@adelphia.net]
Enviada em: s?bado, 15 de mar?o de 2003 16:35
Para: writelog@contesting.com
Cc: PY5EG
Assunto: [WriteLog] SO2R SETUP with WRITELOG
I'm using a home built SO2R application successfully with Writelog and
DX4WIN with W98. I think the key is ensuring your parallel port is
transitioning when switching radios, and ensuring that the Array
solutions
box is looking at the same serial pin as is used by Writelog.
Pin 14 is the one that gets asserted by Writelog for radio switching.
You
can put a voltmeter on the pin to determine if it is switching or not.
I'm assuming you have specified two radios in Writelog, see both of
them,
and the highlight switches between radios as you do.
73 de Larry K7SV
|