Hi Bob,
I had a TS-570 some months ago. There were absolute no problems with
rig-control and WriteLog. It worked a lot better than the rig-control
of my FT-1000MP.
But my experiences say that it is impossible to share one IRQ for
several COM-port without a special device with its own driver software
( like PCI multiport I/O-cards).
If you use the onboard ports together with 2 ports on an ISA-card you
must assign every COM-port its own IRQ.
How to do that depends on several properties of your additional
COM-port-hardware, the BIOS of your computer and the actual hardware
configuration of the PC.
73 + 55
Wolf, DL6JZ
ki6dy wrote:
> Anyone out there have Writelog talking to this radio??? I
> am attempting to
> talk to this rig via COM3 (IRQ4) which is shared with
> COM1 (IRQ4) that talks
> to my KAM OK. I believe I have an IRQ problem even though
> both WIN98 and WIN
> ME show COM3 and COM1 as operational. After setting the
> Ports through
> Writelog it either hangs Writelog or illuninates the CTRL
> on the 570 with no
> frequency information being transfered to Writelog. I
> also have COM2 (IRQ3)
> talking to an FT-1000 with no problems. Wonder if I
> should switch the
> Com3(IRQ4) serial port to Com4(IRQ3) and give it a
> try????
>
> Thanks,
>
> Bob (KI6DY)
>
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
|