I was working with the band-data outputs recently. I found that the pin nrs
given in the WL documentation worked OK once I activated that port for
antenna relays in the setup menu and specified the port address in my ini
file (to "un-gray" LPT2 in the setup menu). Once I did that, the BCD codes
showed up on the port and followed the rig from band-to-band. I don't
remember the pin nrs, but it was advertised.
Jerry W4UK
At 12:11 12/6/02 -0800, Don Melcher wrote:
>Can anybody tell me if I have this right - pins 2,7,8 & 9 provide a BCD
>output for band data?
>
>Don Melcher
>Owner - HF Radio On Board
>www.hfradio.com
>
>_______________________________________________
>WriteLog mailing list
>WriteLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog
|