Thanks Scott and All
With the help of of several I got pointed in the correct direction and then
Scot hit it on the head.
My problem was NOT a WL problem but a setup problem with the sound card
within WL (See Scot's comments below). When I looked at the panel, I found
that Line In was selected. Changing it to Mic fixed the problem.
I hope this will help others that may run into the problem.
Thanks to all that responded.
Don AF4Z
At 11:43 AM 10/27/2002 -0600, Scot Herrick wrote:
>Hi Don,
>
>What you are describing here points to an incorrect setup with the sound
>card in WriteLog. Somewhere, something changed. The section most likely
>incorrect is the 'Receive Selection' on the far right of the WriteLog sound
>mixer.(Start|WriteLog|Sound Board Mixer Control). The trick on this is that
>the audio in on your sound card has to match the selection on the drop down
>box in this control area. If it doesn't, you won't be able to receive or
>record the contest.
>
>I don't know how your audio is getting from your radio to your sound card,
>but most likely from your description it's not going to 'Line In' on the
>sound card, but going to 'Mic.' Check out my web page under the Reference
>section. You'll find 'Sound Cards' there and that should help point the way.
>
>Hope this helps...
>
>Scot, K9JY
>
>See K9JY's WriteLog User Support Site at:
>http://www.k9jy.com
>mailto:scot@k9jy.com
>
>
>
>-----Original Message-----
>From: writelog-admin@contesting.com
>[mailto:writelog-admin@contesting.com]On Behalf Of Don Winn
>Sent: Sunday, October 27, 2002 10:22 AM
>To: w2up@mindspring.com; writelog@contesting.com
>Subject: Re: [WriteLog] Soundcard problem
>
>
>Barry, and All
>
>I can follow Barry's procedure below and I find the Microphone Balance
>select is NOT enabled. Enabling it will allow the decoding to start
>working.
>
>BUT, if I go back to WL and click in the logging area to enter a call, the
>audio dies and I find the Microphone Selected is disabled again. With both
>on screen, I can watch the check go away when I click in WL and see the
>audio come back when I select the Microphone Balance.
>
>I'm sure if it's a WL issue, Wayne will have it fixed shortly. If it's
>not, he can mostlikely explain what is happening.
>
>Don
>
>
>
>At 03:45 PM 10/27/2002 +0000, Barry wrote:
> >Don,
> >Go into the soundcard setup, click Options|Properties, then Recording
> >and OK. Double check the selected audio input and the slider (Line In
> >vs. Mic). Note that you have to be in Recording and not Playback to set
> >these, even if they show up in Playback.
> >Barry W2UP
> >
> >
> >On 27 Oct 2002 Don Winn wrote:
> >
> > > I have developed a problem with my SB16 soundcard working with
> > Writelog. It
> > > has worked for several years so it's not a compatibility issue.
> > >
> > > If I setup for using the soundcard for RTTY, CW or PSK decoding, I get
>no
> > > response in the RTTY or tuning window. If I use another program (MSN's
> > > Messenger Service) and I run their Audio Tuning Wizard, I can then go
>back
> > > to WL and receive fine.
> > > When working and copying RTTY, If I click in the logging area, it dies
>and
> > > I have to go back to the MSN Wizard to get it back.
> > >
> > > I have reloaded WL 10.36G and no help. OS is WINDOWS 98SE
> > >
> > > Anyone had a similar problem??
> > >
> > > Don AF4Z
> > >
> > >
> > > _______________________________________________
> > > WriteLog mailing list
> > > WriteLog@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/writelog
> >
> >--
> >Barry Kutner, W2UP Internet: w2up@mindspring.com
> >Newtown, PA Frankford Radio Club
> >
>
>
>_______________________________________________
>WriteLog mailing list
>WriteLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog
|