>From the WriteLog Help Files (not on the web site yet at K9JY de K9JY...):
"the letter ?N? optionally followed by a digit n the serial number is sent,
padded with leading zeros if necessary to get to n digits. If the mode is
CW, the digits are translated to letters according the [Cut-Numbers] section
in WRITELOG.INI."
So you need %N3 for TT6.
PLUS, you now MUST designate the letters in a substitution of the number in
the WriteLog.ini file:
"This section contains the mapping for cut numbers for handing the %N
command in CW transmission. Here is what you will get if you don?t set up
this section:
[Cut-Numbers]
0=0
1=1
2=2
3=3
4=4
5=5
6=6
7=7
8=8
9=9 "
So add this section to your WriteLog.ini file (or find it as a default). If
you want 'T' to be your letter for Zero, make the first line '0=T' and
that's what you'll get.
This set up should be the cat's meow for cut numbers...
CU...Scot, K9JY
See K9JY's WriteLog User Support Site at:
http://www.k9jy.com
mailto:scot@k9jy.com
-----Original Message-----
From: writelog-admin@contesting.com
[mailto:writelog-admin@contesting.com]On Behalf Of k0co
Sent: Saturday, October 05, 2002 1:15 PM
To: ham_Writelog Reflector
Subject: [WriteLog] No CW TTT fill?
I just upgraded to 10.35F, and now get 006 instead of TT6 in CW fills with
the %3 command. What gives?
k0co jack
John F. Dougherty, P.E.
K0co
Rocking JbarA Ranch
Como and Aurora, Colorado
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
|