All packet spots will show up in the 'WriteLog Packet Terminal' window.
Editing the sub-bands will prevent them from showing in the 'Packet Spots'
window, the window where you can double-click on a spot and WriteLog moves
it to the Entry window and changes your radio to the right frequency with
rig control.
WriteLog comes with everything available on everything. So, to narrow the
packet spots to your mode, two things need to be done. First, edit the
bands. Second, click on 'In-band only' in the Packet Spots window.
To edit the bands, go to your Start menu (this is a separate program from
WriteLog), Programs, find WriteLog, then find 'Edit sub-bands.' Edit the
frequencies and save the files.
Hope this helps.
CU...Scot, K9JY
See K9JY's WriteLog User Support Site at:
http://www.k9jy.com
mailto:scot@k9jy.com
-----Original Message-----
From: writelog-admin@contesting.com
[mailto:writelog-admin@contesting.com]On Behalf Of FireBrick
Sent: Saturday, August 24, 2002 6:49 AM
To: Writelog List
Subject: [WriteLog] setup bands?
Can I edit the band segments so that spots for cw or ssb do not show up in
the cluster window?
The Show Bands menu item shows the entire band for FSK which is correct.
If I edit it so that 20 meter FSK is only from 14070 to 14150, will spots
for lower and higher frequencies show up in the cluster window?
-----------------------------------------------------
I'm so clumsy I trip over cordless phones.
-----------------------------------------------------
Bill H. in Chicagoland
w9ol@billnjudy.com
www.billnjudy.com
http://files.billnjudy.com
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
|