> I use a ICOM 746 and CT-17 to log contests. I unplug the CT-17 between
contests. I
> downloaded 10.33c. I plugged in the CT-17 prior to the NAQP and it
indicated NO RIG. Any
> ideas where to start checking for the problem. It may have been caused by
the new version,
> but I have no idea how.
> Ed KN4Y
2 more comments:
1. Make sure your baud rate still agrees in Wl and the rig. I have both
set for 9600. Icom seems finicky about not using AUTO settings.
2. I used 10.33C for the NAQP RTTY with 2 Icom radios and it worked fine.
Then I upgraded to 10.34B - I just tried it and was surprised to see that my
Setup Ports settings weren't retained as they always have been before. They
all showed Ten Tec. Simple to rectify, but I don't remember having to Setup
Ports again after upgrading before.
2.5 The order of plugging and unplugging doesn't affect this. WL will find
the rig when and if it presents itself.
|