I just tried it and had a different experience. Running XP Pro on Athlon
1500 512MB RAM. When I tried it with it's default port addresses, I was
able to access all 3 LPT ports in the Writelog Ports Setup screen. However,
doing so on any of them didn't get LPT CW keying to work. Then went back
and put in only the address as shown in the control panel for the LPT (i.e.
the standard 0378 - 037F Hex) and only LPT2 was available for checking in
Writelog - curious. Again it didn't work. Fiddled a bit more with the
numbers, with no change. Fortunately I had established a restore point
before doing this so I did a restore to put things back. By-the-way, I used
DX4WiN CW LPT Keying as a cross check to just make sure I hadn't messed
things up too much both with the driver installed and without. It worked
just fine in either case.
73 Stan, N3HS
-----Original Message-----
From: writelog-admin@contesting.com
[mailto:writelog-admin@contesting.com]On Behalf Of A. Sewell N5NA
Sent: Tuesday, July 30, 2002 7:46 PM
To: WriteLog@contesting.com
Subject: [WriteLog] LPT Keying / Windows 2000 using UserPort
Please excuse me if this has been posted previously. If it has I must have
missed it.
I downloaded a small program today called UserPort which makes it possible
to access the hardware I/O ports directly under Windows NT/2000/XP just like
95/98/ME. I installed it on my work notebook which runs Windows 2000 and
loaded Writelog to see if I could key thru the CW port.
After about 5 minutes of tinkering I got it to key my rig thru the CW port.
I haven't tested it extensively to see if there are any side effects but so
far it looks good.
It is very simple to install and set up. Just follow the documentation that
comes with it. The only thing I had to do was go into Control
Panel/System/Hardware/Device Manager and check the resources the LPT port
was using. Mine was 03BC - 03BF and 07BC - 07BE.
I then ran the UserPort program and set it to use 3BC - 3BF.
Voila, it started keying!
UserPort is free and can be downloaded at
http://www.embeddedtronics.com/design&ideas.html
It is supposed to work with XP so I would be interested to hear any reports.
I've been reluctant to upgrade from Windows 98 to XP because I didn't want
to lose my LPT port keying.
73,
Alan N5NA
I
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
|