WriteLog
[Top] [All Lists]

[WriteLog] interfacing IC-756PROII for Writelog SO2Roperation

To: <writelog@contesting.com>
Subject: [WriteLog] interfacing IC-756PROII for Writelog SO2Roperation
From: jpixton@shentel.net (Jerry Pixton)
Date: Wed, 05 Jun 2002 11:19:26 +0000
Bill,

I have chosen to use FSK for my IC-756PROII so that I can use the RTTY 
settings and filter for rtty. However, I also ran the AFSK line from the 
Soundboard that Writelog controls so that I could play SSB wave files. 
Writelog seems to control the PTT fine in all modes. However, I did use the 
PTT line for my foot switch which the W4XD keyer switches from Left rig to 
Right rig. My other radio is the FT01000mp. So far this station seems to be 
coming together nicely.

Please post any other tips you get.

Jerry, W6IHG


At 09:01 AM 6/3/2002 -0700, William Hein, AA6TT wrote:
>Looking for tips on interfacing an IC-756PROII for Writelg SO2R
>operation (it will be on the right side of the console and
>generally function as the S&P rig, FT-1000D will be on the left
>and function as the run rig).
>
>** I have the W5XD multi-keyer connected to my computer's COM1
>and it's working fine.
>
>** I have my computer's COM3 connected to the PROII via a CT-17
>level converter running @ 9600 baud.  Again, working fine (I
>changed the PROII hex address to be the same as the plain vanilla
>PRO).  (I elected not to share a serial port for the W5XD keyer
>and rig data as this isn't supported by my day-to-day logging
>software DXbase 2003.)
>
>QUESTION 1:  what's the best way to have the computer key the PTT
>line on the PROII for all modes of operation (CW, SSB, AFSK and
>RTTY)?
>
>QUESTION 2:  what's the best way to send soundboard voice keyer
>and AFSK signals to the PROII?  Via pin 4 of the ACC(1)
>connector?  Would prefer a solution that will work for both SSB
>voice keyer and AFSK data operation without reconfiguration of
>cables.  Are audio signals from ACC(1) affected by the MIC GAIN
>and COMP pots (I tried following the ACC(1) and MIC wiring on the
>PROII schematic but nearly went blind in the attempt)?
>
>Thanks,
>Bill AA6TT
>
>------------------------------
>William H. Hein, AA6TT
>10 Clark Road
>Topsham VT 05076-3086 USA
>tel 802/584-4317
>-------------------------------
>http://www.AA6TT.com
>email Bill@AA6TT.com
>MSN IM william_hein@hotmail.com
>-------------------------------
>_______________________________________________
>WriteLog mailing list
>WriteLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog

------------------------------------------
Dr. Jerry R. Pixton, PIXOS Designs LLC
http://www.pixos.com/designs/RadioTuner/
jpixton@shentel.net
------------------------------------------



<Prev in Thread] Current Thread [Next in Thread>