I think if you go to the System, Hardware, option and look at your sound
card options you may be able to change the 'resources' or one. It may just
be a resource/irq conflict.
----- Original Message -----
From: "Bill Lakatosh" <wlakatos@nrao.edu>
To: <writelog@contesting.com>
Sent: Wednesday, May 29, 2002 2:05 PM
Subject: [WriteLog] 2 sound cards with writelog ??
> Hello,
>
> I just purchased WriteLog at Dayton, still trying to figure out
> all it has to offer. I do have one basic question. When I put two sound
> cards in my computer, a Dell 1.2 Ghz machine, I could not get the
> machine to boot up. Only after removing one of the boards did my machine
> boot up normally.
>
> The boards I used were two Sound Blaster Live, 32 bit cards.
> Wonder what I missed in the installation ? The single board works very
> well, in fact I tried both boards and they both work well as a single
> board. Only when I put both in and try to run the machine do I have a
> problem.
>
> There is probably something obvious I'm missing, any advice
> would be greatly appreciated !
>
> Thanks
> very Much !, Bill W4TJ
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
>
|