WriteLog
[Top] [All Lists]

[WriteLog] Hello and help.

To: <writelog@contesting.com>
Subject: [WriteLog] Hello and help.
From: gbaron@charter.net (Gil Baron)
Date: Sat, 25 May 2002 21:02:11 -0500
CW on COM 2, Rig on COM3 All Mode PTT on CW RTS checked, PC Generates
Checked for CW type, works fine for my TS870. It should work for you too if
you choose any 2 ports.
CW PTT setup should be the LPT/COMM RTS selection.
Be sure RTS and DTR are not tied together on your Cable.
Unfortunately you cannot use different ports for Keying and PTT with
WriteLog and they cannot use anything but RTS for PTT with a COMM port. I
had to redo my whole system as a result of that lack of function and make a
cable that could connect to both the keying and the PTT lines which meant
splitting it out , but it does work.
You could use the rig CAT (rig command) to do the PTT and that would
eliminate nay need for a COMM. port at all for the PTT operation. That can
solve some problems but IMHO is not the way to go if you can avoid it.
, they must be the same port.


> -----Original Message-----
> From: writelog-admin@contesting.com
> [mailto:writelog-admin@contesting.com]On Behalf Of N8IE
> Sent: Saturday, May 25, 2002 8:09 PM
> To: Write Log
> Subject: [WriteLog] Hello and help.
>
>
> I just bought WriteLog at Hamvention and need some help with my com port.
>
> I have a CAT cable on com2 and an interface for RTS and DTR
> keying on com1.
> This setup works FB with MixW, but with WL unless I set the keying to RTS,
> when I exit the setup screen the rig goes into key down mode. If I make it
> RTS then it won't key the rig at all.
>
> The rig is a TS-570DG and the PC is a P3/500 running W2K Pro.
>
> 72, oo
> Dan, N8IE
> FPqrp #-6, QRP-l #1404, FISTS #4985
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>



<Prev in Thread] Current Thread [Next in Thread>