WriteLog
[Top] [All Lists]

[WriteLog] IC-756PRO-II support

To: <writelog@contesting.com>
Subject: [WriteLog] IC-756PRO-II support
From: Zev.Darack@banklink.com (Darack, Zev)
Date: Wed, 22 May 2002 12:31:25 -0400
This is the information in the writelog manual for overriding the icom
address in the INI file.  Not quite sure how to do it but it shouldn't be
too hard to figure out with some trial and error.

73,
Zev N2WKS

WRITELOG.INI [Rigs]
[Rigs]
Setting this entry to 1 causes the WriteLog Icom driver to send a split
on/off command to the
rig every time it polls the rig for its frequency. This means that WriteLog
is sure to know
whether the rig is set for split.
IcomForceSplit=1
Setting this option to 2 causes WriteLog to do the same as setting to 1,
but, in addition, If you
tune the rig from its front panel more than 500Hz after WriteLog has set it
to split, then
WriteLog automatically turns the split off.
IcomForceSplit=2
Note: WriteLog versions 10.30 and older behave like option (2) above for all
non-zero settings
of this option.
The following entries override WriteLog's default setting for the Icom rig
address for the
various Icom rigs. All rigs that have Icom rig addresses have corresponding
entries in
WriteLog.ini here under the name that matches the name in the Setup Ports
dialog including
space characters!
Icom IC-781=0x33
Icom IC-756PRO=0x12


 -----Original Message-----
From:   William Hein, AA6TT [mailto:Bill@aa6tt.com] 
Sent:   Wednesday, May 22, 2002 12:15 PM
To:     writelog@contesting.com
Subject:        [WriteLog] IC-756PRO-II support

Does Writelog support the Icom IC-756PROII?  I don't see this rig
listed in the Setup->Ports form.  When I try using the IC-756PRO
selection I get a "comm port not available" error message.  I
selected the Icom std 1200-baud.

I successfully use DXBase 2003 with the PROII every day,
connected thru the same serial port and CT-17 level converter.  I
am running Writelog 10.32E on a 300-MHz Pentium running Windows
2000 Pro.

Am I doing something wrong?  Anyone else using a PROII with
Writelog?

Bill

------------------------------
William H. Hein, AA6TT
10 Clark Road
Topsham VT 05076-3086 USA
tel 802/584-4317
-------------------------------
http://www.AA6TT.com
email Bill@AA6TT.com
MSN IM william_hein@hotmail.com
-------------------------------
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog

<Prev in Thread] Current Thread [Next in Thread>