You might check within Writelog(not ini file) that the port setting is set
to 1200baud and not auto. Unless someone had diddled with the dip switches
inside the radio the address should be ok.
John N1JM
----- Original Message -----
From: "Frank Grossman (WB2BXO)" <flgrossman@earthlink.net>
To: "Gary D Elliott" <k7ox@pipeline.com>; <Writelog@contesting.com>
Sent: Friday, February 15, 2002 9:14 PM
Subject: Re: [WriteLog] Icom 761 Radio Control
> Gary,
>
> Take a look at the CT-17 manual. I think there's an address you need to
set
> for Icom radios. I can't tell you for certain because I'm not at my
station
> location. :)
>
> Frank
>
> ----- Original Message -----
> From: Gary D Elliott <k7ox@pipeline.com>
> To: <Writelog@contesting.com>
> Sent: Friday, February 15, 2002 1:04 PM
> Subject: [WriteLog] Icom 761 Radio Control
>
>
> > Hello
> >
> > Anybody using a Icom-761 radio control with WL ? I am using the Icom
> > commercial interface on comm 1 and baud speed for the comm port in the
ini
> > file is set for 1200 baud as required for all Icom radios. I can not
get
> my
> > radio to talk at all to WL. Suggestions ? Thanks in advance.
> >
> > 73 Gary
> >
> >
> > If you are using a 761 with wl can you send me your ini file as an
> > attachment so I could look at it ?
> >
> >
> >
> >
> > _______________________________________________
> > WriteLog mailing list
> > WriteLog@contesting.com
> > http://lists.contesting.com/mailman/listinfo/writelog
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
|