Dave,
Look in Writelog help files under "rig interfacing" and "cw interfacing"
You will want both the rts and the dtr lines as the FT1000mp seems to have
a bug where it ignores the ptt command sent via the CAT interface when in
CW mode. This can be the same comm port as used for CAT control and writelog
Jerry, W6IHG
At 01:53 PM 12/29/2001 -0600, Iowaguy wrote:
>Greetings...
>
>Am new to Writelog and to this reflector but would like to pose a question
>that, I'm sure, has been asked many times before. I did look in the
>archives to see if my question had been addressed but did not find an answer
>(it's probably in there somewhere).
>
>I run a FT-1000MP. In my previous contest logging programs, I have always
>used the LPT port for CW interface to the computer. I recently upgraded
>computers and am using W2K-Pro. It appears that W2K will not support the
>LPT interface so I will need to tie into the existing serial interface to
>the rig. I'm looking for pinout info as to where the PTT (RTS) and CW (DTR)
>functions tie on both the computer and rig end of the cable. Does anyone
>have this info handy? Also, are there any commercially available interface
>cables already Y'd off and built up with the opto-isolator?
>
>73 and HNY...Dave
>W0FLS
>
>
>_______________________________________________
>WriteLog mailing list
>WriteLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog
------------------------------------------
Dr. Jerry R. Pixton, PIXOS Designs LLC
http://www.pixos.com/designs/RadioTuner/
jpixton@shentel.net
------------------------------------------
|